1660K014E
Page 2 of 26
Installation of the DC-10SR
4 fixation points
The DC-10 SR displays can be fixed to the wall in two ways:
1
– Hanged. Place 2 of the supplied plug at 314mm from one to the other. Insert the screws leaving
their head outside for 4mm. Hang the display using the upper-side zig-zag.
2
– Screwed. Remove the methacrylate cover. Place the 4 supplied plugs at the distance showed in
the drawing. Place the 2 upper screws, leaving their head outside for 4 mm. Hang the display using the upper-
side zig-zag. Place the lower screws Tighten all the screws. Replace the methacrylate cover.
Powering the display
Power supply must be from
100VAC to 240VAC, 50/60 Hz .
You must use a Schuko type plug that
has grounded terminal.
In case you have to lengthen the cord, the connection must be made on the terminal located within
the display.
DC-10SR characteristics.
Power supply
............................................... 100 VAC a 240 VAC 50/60Hz
Consumption
................................................ 35VA
Consumption at minimum brightness
....... 13,2VA.
Display
.......................................................... 4 digits 7segments 100mm two central dots. Red LED.
....................................................................... Visibility 50 meters.
Environmental conditions
.......................... Operating temperature: -20 to 60ºC.
....................................................................... Storage temperature: -30ºC to 70ºC
....................................................................... Relative humidity: 5-95% non condensation.
....................................................................... Maximum environmental lighting: 1000 lux.
....................................................................... Protection IP 41.
Weight
........................................................... .4,5 Kg.
Timed power-up of the display
This display operates in two operation modes: full-operative mode and power-saving mode. In power-
saving mode the display does not show the time in order to save energy when the display is not needed. If the
power-saving function is not needed and the display should always powered up, the both power-up and
power-down times must be the same.
