Distar CACC, Руководство по эксплуатации

Страница: 15 / 52

WARNING:
Before starting the work, please read the following instructions carefully.
Strictly observe the safety precautions when using the diamond disk and the cor-
responding equipment.
Before starting any work (movement, replacement of tools etc.) with electrically
driven tools, pull the plug out of the wall socket or, respectively, remove the battery from
the device.
Before each use, perform a visual check for possible damage of the diamond tool.
Never use damaged diamond tools.
Damaged, improperly installed, or improperly operated diamond tools can pose an
extremely high risk when used!
Wear safety goggles with side protection (a safety mask with full protection), a
respirator, gloves, and earmuffs when using the tools. Always wear safety shoes (use an
apron if necessary);
The processed material must be securely attached;
Always use the protective cover on your equipment! Working without a protective
cover and protective equipment is prohibited (refer to the manufacturer’s operation manual
for the equipment)!
Do NOT use the lateral surface of the diamond layer when working (only use it for
grinding operations);
RECOMMENDED USE:
Make sure that the diamond tool you purchased is suitable for the material to be
cut. Pay attention to the material types indicated on the packaging and in this manual (drill
designation).
The outer diameter and tool mounting hole of the diamond tool must match the
characteristics of your equipment.
PROPER INSTALLATION:
Before attaching the drill, check its mounting surface (adapter shank) for any nicks,
dents, or other damage, and clean it from dirt and dust if necessary.
Screw the diamond drill onto the adapter with a wrench until its butt end is pressed
against the corresponding end of the drill mounting surface. Check that it sits tight, other -
wise excessive radial run-out is possible.
Clean mounting face (SDS Plus) of the center drill included in the CACC (DDS-W) kit
from dirt and dust. Then insert it into the chuck of your power tool.
15