4
3
1a-1. Installing the Rubber Pads
1a-2a. For Concrete Floor Mounting
60mm
(
2.4"
)
62mm
(
2.4"
)
ø12
m
m
(
ø
1/
2 "
)
• Lift the steel base by grasping the cable ties.
• Peel off the backing paper from the rubber pads and stick the rubber
pads on to the steel base.
Mark the exact location of mounting holes and pre-drill these mounting holes with a 12mm drilling bit to
at least 62mm in depth. Remove the dust in the holes.
First tighten the iron expansion bolts with an Allen key, and then loosen the iron expansion bolts in order
to separate the bolts and the expansion tubes.
A
B
C
D
G/Z2
1a-2b. For the Floor Stand Mounting
Remove the cable ties.
Attach the column to the steel base using the appropriate screws. Tighten all screws with an Allen key.
G/Z2
E
• Attach the connecting plate to the bottom of the column using the
appropriate screws. Tighten all screws with an Allen key.
• Insert an expansion tube into each of these holes. Using the bolts
mount the column to the floor. Tighten all screws with an Allen key.
G/Z2
D
G/Z2
F
V
Attach the left and right base to the middle base using the appropriate screws. Tighten all screws with an Allen key.
1b-1. Assembling the Base
N
P/Z3
Note:
With the brake
wheels facing forward
.
H
I
J
Each castor can be adjusted independently
for fine tuning. Slightly turn the nut to lower
or raise the base.
R
M
1b-2. Attaching the Column to the Base
Attach the column to the assembled base using the connecting piece, secure them with the appropriate screws.
NOTE:
Lock the brakes on the casters to avoid any sudden movements during installation
.
O
P/Z3
Q
1a.
VWALLBS
For
1b. For VWALLWH