Please make sure you don’t have a USB device plugged in while going through the setup process.
Once you are setup you can then plug your device in.
Switch your TV on and select the correct video input.
07
The Country setup install screen
should appear on your TV*. Set the
Region closest to you.(this is only to
receive ads for your area on TV1) and
press OK.
An auto scan will now start, please
do not push any buttons until it has
finnished. Once it has finnished if the
signal from your dish is good TV1 will
appear and you can start using your
satBox Ultra.
Switch the satBox on and wait for it to boot up.
* If the Country Setup screen does not appear go to the
Menu
select
Installation
then
Factory Default
. The default
pin/password is 0000.
Open the battery cover of the remote control and put two
AAA size batteries so the ‘+’ and ‘-’ marks on the batteries
match the ‘+’ and ‘-’ marks inside the remote control.
Replace the battery cover.
