121716
9
For AUX mode, the first group of flashes tells you what the
AUX
mode controls. A quick flash (zero) before the three-digit
code is for a TV; one regular flash is for a VCR; and two flashes
is for a tuner, amplifier, or cable box. For example, if the TV
code is 570, the
AUX
mode button flashes once quickly, pauses,
flashes five times, pauses, flashes seven times, pauses, and
flashes once quickly.
C
HANGE THE
A
DDRESS
Because UHF signals travel long distances and go through walls,
a neighbor’s remote may control your receiver by mistake. To handle
this problem, you can change the remote control and receiver address.
1. Open the
Important System Information
screen.
Press the receiver’s front panel
SYSTEM INFO
button.
The
Important System Information
screen shows
a
Remote Address
.
Write down this number:
2. Press and hold the
SAT
mode button about three
seconds, until all the mode buttons light up,
and then let go of the
SAT
button. The
SAT
mode
button will blink.
3. Use the number buttons to enter any number
from 1 to 16, but not the one you found in step 1. The
SAT
mode button goes out after you enter each digit, and then lights
up again.
Write down the number you entered:
4. Press the
POUND
(
#
) button.
If you entered the address correctly, the
SAT
mode
button will flash three times.
5. Press the
RECORD
button.
6. Make sure the
Remote Address
on the
Important
System Information
screen now is the same as the
one you entered in step 3. If it isn’t, the remote can’t
control the receiver.
7. To check the remote control address, press and hold
the
SAT
mode button for three seconds. Then, let go
of the
SAT
button, and press the
POUND
(
#
) button
twice. The
SAT
mode button flashes the same number
of times as the address you entered in step 3.
text_dishpvr.fm Page 9 Friday, February 28, 2003 1:22 PM
