Page 7
4. The switch takes the place of a ground block. Article
820-40 of the
National Electrical Code
(NEC) states that
you should locate a ground block as close as possible to
where you have the system connected to the ground (for
example, to a water pipe or rod driven in the ground). So,
do the same for the switch.
After you have connected cables and DP34 Switches to all
receivers in the system, you will need to run
Check Switch
on each receiver in your system,
one at a
time.
To do this, follow these instructions for each receiver:
1. Select the
Main Menu, then System Setup,
Installation
, and
Point Dish/Signal,
or push 6-1-1 on
the remote.
2. A
Point Dish/Signal
menu similar to the one shown as
Figure 2 will open.
• Do not connect the receiver to the ports
labeled “To additional switch” as this can
cause other receivers in the system to
experience loss of video.