Installing an Attenuator
104333
17
I
NSTALLING
AN
A
TTENUATOR
Unwanted UHF signals may block signals from the remote control
to the receiver. To prevent such blockage, you can install a 10 dB
attenuator. This will help keep out other UHF signals, but also reduce
the distance at which you can use the remote control.
4. Press the
Pound
(
#
) button. If the address you
entered is valid for the remote control, the
SAT
mode button backlight flashes three times.
5. Press the
Record
button.
The
Remote Address
on the
Important
System Information
menu should match
the one that you entered.
6. To check the address, press and hold the
SAT
mode button for three seconds. Then, press the
Pound
(
#
) button twice. The
SAT
mode button
backlight flashes the same number of times
as the address.
7. Press the
Select
button.
1. Remove the UHF antenna
from the
UHF Remote
Antenna
connection on the
receiver back panel.
2. Attach a 10 dB attenuator to the
UHF Remote Antenna
connection.
3. Attach the UHF antenna to the
attenuator.
Содержание digital remote control
Страница 1: ...User Guide A single remote to control up to four devices...
Страница 33: ...104333 31 Notes...
Страница 34: ...32 104333 Notes...
Страница 36: ...FOR ALL YOUR CUSTOMER NEEDS CALL DISH NetworkTM CUSTOMER SERVICE at 1 800 333 DISH 3474 104333...
