7
P
ROGRAMMING
THE
R
EMOTE
TO
C
ONTROL
A
S
ECOND
R
ECEIVER
IN
AUX M
ODE
If you have another DISH Network receiver installed, you can use this
remote control in
AUX
mode to operate it along with your new
receiver. When you program the remote control to operate the other
receiver, the remote will send IR signals to that receiver, so the line of
sight to the second receiver must be unobstructed. You can program the
remote control to operate any other DISH Network receiver,
except
for:
•
TV2 on DISH 322, DISH Player-DVR models 522, 625, and 942,
ViP222, ViP222k, ViP622 DVR, ViP722 DVR or ViP722k DVR
•
DishPlayer 7100/7200
1
Turn on the other receiver and open the System Information
screen. (For help opening the System Information screen, refer to
the user guide for the other receiver.)
Write down the TV2 address shown:
2
Press and hold the
AUX
button until all the mode buttons light up,
and then release the button. The
AUX
button flashes.
3
Use the
NUMBER PAD
on the remote control to enter a 3,
followed by the address you wrote down in step 1.
4
Press
POUND (#
). The
AUX
button blinks three times.
5
Press
RECORD
to verify that the address in the remote control
now matches the address for the receiver.
M
AKE
SURE
THE
REMOTE
CONTROLS
THE
AMPLIFIER
’
S
VOLUME
IN
OTHER
MODES
:
M
AKE
SURE
THE
REMOTE
CONTROLS
THE
TV’
S
VOLUME
IN
OTHER
MODES
:
6
Press the
SAT
mode
button.
6
Press the
SAT
mode
button.
7
Press the plus (+) and
minus (-) sides of the
VOLUME
button.
7
Press the plus (+) and
minus (-) sides of the
VOLUME
button.
8
Your tuner/amplifier’s
volume changes and the
AUX
mode button lights
instead of the
TV
mode
button.
8
Your TV’s volume changes
and the
TV
mode button
lights instead of the
AUX
mode button.
Control Amplifier Volume
Control TV Volume
