PAGE 20 — MRH601DS VIBRATORY ROLLER • OPERATION MANUAL — REV. #1 (06/10/20)
OPERATION
STARTING
1. Move the throttle lever to the operation position
Figure 11. Throttle Lever (Operation Position)
2. Move the travel lever to the stop (neutral) position
3. Move the vibration on/off switch to the off position
4. Move the light switch to the off position (Figure 12).
Figure 12. Travel Lever, Vibration Switch and
LIght Switch
CAUTION
DO NOT
attempt to operate the roller
until the Safety Information, General
Information, and Inspection sections
of this manual have been
read and
thoroughly understood.
CAUTION
When the engine is running, never turn the starter key
to the
START
position.
THROTTLE LEVER
OPERATION
STOP
TRAVEL
LEVER
VIBRATION SWITCH
(ON-OFF)
LIGHT SWITCH
STOP(NEUTRAL)
OFF
OFF
5. Open the fuel cock.
6. Insert the key into the key switch and turn it to the
operation
position (Figure 13). The buzzer should
sound at this time.
Figure 13. Starter Key (Operation Position)
7. Turn the key to preheat position and wait until the glow
lamp lights (about 5 seconds). The glow lamp goes out
automatically after 5 seconds.
8. After preheat is complete, turn the key to the start
position. After the engine is started, take your hand
off the key. Buzzer stops when the engine speed
increases.
9. Turn the starter key further to the right to the start
position (Figure 13) to start the engine. Buzzer stops
sounding when the engine speed increases.
10. If the engine fails to start, do not continue to rotate the
starter key for more than 5 seconds. Return the key
to the operation position and wait 20 to 30 seconds
before starting again.
11. After starting the engine, continue to warm up the
engine for about 3 to 10 seconds especially in cold
weather.
GLOW LAMP
KEY SWITCH
KEY SWITCH
PREHEAT
(GL)
OPERATION
(ON)
STOP
(OFF)
START
(ST)
NOTICE
Machine will not start if the travel lever is not at the
stop position.
To
order
go
to
Discount-Equipment.com
