PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•
Careless installation and operation can result in equipment damage
.
Requirements:
Introduction
This simply aux adapter allows users to connect and play any audio device with a
3.5mm jack to select 1998-05 Honda and Acura CD changer controlling radios.
Simply connect the adapter to the 14-pin CD changer port on the back of the
radio and audio device to the 3.5mm jack and enjoy stored content or music
from the internet if using Smartphone. The HON98-AUX replaces factory
external CD Changer or Slave CD player.
Warning:
Honda 6-disc CD changer radios are not compatible.
Installation
1.
Remove factory radio from the dash to gain access to the connector.
(Vehicle specific radio removal instructions are not part of this guide
but may be available upon
2.
Disconnect any factory accessory connected to the 14-pin radio
connector (See
Fig. 2
)
Note to Vehicles with Slave Cassette:
If vehicle has slave cassette,
the
HON98-AUX connects to the Slave cassette (not the radio)
3.
Connect 14-pin plug (See
Fig. 1
) from HON98-AUX to radio or slave
cassette (See.
Fig. 2
)
Fig. 1
Fig. 2
14-pin port
4.
Connect one end of supplied 3.5mm audio cable (See
Fig. 3
) to adapter
jack (See
Fig. 4
), route other end to the front of the dash or wherever
audio device will reside (within 3 ft.)
Fig. 3
audio cable
