Some radios may also include a Yellow plug.
Yellow plug (if present) must remain connected
otherwise alarm, remote control or subwoofer
may no longer work.
3.
Connect installation harness Molex plug (See
Fig. 4
) to green module
22-pin Molex connector (See
Fig. 5
)
Fig. 5
22-pin Molex connector
4.
Set dip switches
# 2 & # 8 t
o “ON”. All others
remain
“OFF” or Up
Fig. 6
dip-switches
5.
Tap/splice installation harness Accessory wire (See
Fig. 7
) to
accessory supply in vehicle.
We recommend
Pin 7
(usually yellow/green stripe) on radio connector
(A)
(See
Fig. 3
)
Fig. 7
6.
Secure module and proceed to next section
Pairing:
Pairing process varies among devices but basic steps are the same. This
process is done upon initial install and will not have to be repeated
1.
Turn Ignition and radio
“ON”
Blue LED inside module will flash
2.
On A2DP device: go to
Settings, Wireless & Networks, Bluetooth
Settings
3.
Select to enable
Bluetooth
.
4.
Select Bluetooth settings
5.
Tap
Scan for devices
.
6.
Wait for Bluetooth device name to appear and select it.
LED inside module will glow steady when paired
