PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor
charges or modifications. Exercise due-diligence when installing this product.
•
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•
Careless installation and operation can result in equipment damage
.
Requirements:
CD CHANGER CONTROLLING RADIO
Introduction:
Just because you drive an older car does not mean you settle for old
technology. The A2D-TOY03 updates select 2003-12 Toyota/Lexus/Scion
radios to support music streaming connection from Smartphone, Tablet, Kindle
and more.
The A2D-TOY03 has the option to retain SiriusXM (if subscribed) or a remote
CD changer or both. The module connects to the radio 12-pin socket and after a
short paring session, users are able to enjoy the best sound possible on the
car speakers!
See
Frequently Asked question
at the end of this guide for more details.
Installation:
1.
Remove Toyota radio from dashboard to gain access to the
connectors. (Vehicle specific radio removal instructions are not part
of this guide, but available upon request)
2.
Locate 12-pin radio socket (See
Fig. 2
). If socket t is empty, simply
plug-in the module 12-pin plug (See
Fig. 1
) and
proceed to “Pairing”
section on page 3.
Fig. 1
12-pin plug
Fig. 2
Radio 12-pin connector
3.
If vehicle has XM module or remote CD changer; disconnect 12-pin
plug (See
Fig. 1
) from radio and connect to 12-pin socket on module
harness.
4.
Connect module harness 12-pin plug to radio socket vacated in step 3.
5.
Proceed to pairing.
Pairing:
The pairing process varies among devices but the basic steps are the same.
Pairing is done upon initial install and will not have to be repeated.
1.
Go to device
Settings, Wireless & Networks, Bluetooth Settings
2.
Select
Bluetooth
and turn on.
3.
T
ap “
Scan” or “Search”
for devices.
4.
Wait for the Bluetooth device name to appear and select it. (See
Fig. 3-
not retaining factory option
or
Fig4
- retaining factory option)
Fig. 3
