5.
Connect factory antenna plug (See
Fig. 3
) to included antenna socket
in
Fig. 4
marked “TO ANTENNA”
Fig. 4
6.
Connect included antenna plug in
Fig. 4
marked “TO RADIO” to vacated
antenna socket on radio (in step 4).
Ensure plug is fully seated.
7.
By default, the modulator tuning frequency is set to 87.9MHz. If use
wished to switch to 88.3MHz; locate frequency switch (top left), insert
small screwdriver etc. to move switch to desired frequency (See
Fig. 5
)
Fig. 5
8.
Secure module behind radio cavity and proceed to next step.
9.
Make note of frequency selection from step 7 as this will be needed in
Bluetooth operation section below.
Optional AUX input
Any RCA cable will suffice or purchase our
and connect 3.5mm
(headphone jack) devices. Drill l9/64-inch hole in mounting panel and secure
jack to dashboard, ensure mounting panel is no thicker than
4mm
otherwise the
threads won’t protrude enough to engage nut. (If necessary, use Dremel or
sander to thin panel).
Note: AUX connection not required for music streaming to function
Pairing
Pairing process varies among devices but basic steps are the same. This
process is done upon initial install and should not have to be repeated.
1.
Turn ignition and radio “ON”
2.
Open smart device
Bluetooth Settings and enable Bluetooth
3.
Tap
Scan (Search) for devices
.
4.
Wait for Bluetooth device name to appear and tap
5.
Connected is heard on car speakers
