Assembly
1. Deploy Stand
(see Figure 1).
1. Set engine assembly on flat surface and swing the stand into position.
2. Insert the lock pins into the holes in the stand base to secure.
3. Fully insert the drawbar in the receiver and insert the lock pin.
4. Attach the hitch pin to the end of the drawbar.
Note: Drawbar installation is optional for towing behind vehicle.
The drawbar can install in two different positions depending upon the
hitch height of the tow vehicle.
2. Attach Wheels
(see Figure 2).
1. Tilt the engine assembly forward until it rests on the drawbar.
2. Slide the axle through the wheel bracket.
3. Position wheels on the axle using washers on both sides.
4. Insert lynch pins to secure wheels to the axle.
3. Attach Inlet Tube
(see Figure 3).
1. Align inlet tube with stud bolt on the closure plate and secure with
M8 nylock nut.
2. Fasten inlet tube to closure plate with M8 x 20 bolt and M8 nylock
nuts in 2 places.
3. Attach lynch pin chain to spring plunger.
7
Figure 1
ENGINE
ASSEMBLY
STAND
RECEIVER
HITCH
PIN
DRAWBAR
LOCK
PIN
Figure 2
LYNCH PIN
(2 Plcs)
AXLE
WASHER
(2 Plcs)
WHEEL
BRACKET
WHEEL
(2 Plcs)
INLET
TUBE
STUD
BOLT
M8 x 20
BOLT
(2 PLCS)
M8
NYLOCK NUT
(3 PLCS)
CLOSURE
PLATE
Figure 3
LYNCH PIN
CHAIN
SPRING
PLUNGER
