Dirty Hand Tools 101100, Руководство по эксплуатации

Страница: 18 / 20

Semi-Trash Pump Troubleshooting
18
PROBLEM SOLUTION
Pump overheats
• Incorrect or not enough lubrication. • Lubricate using recommended oil or grease according to
directions.
• Worn parts. • Have qualified technician inspect internal mechanism and
replace parts as needed.
Unit stalls
• Low engine speed. • Qualified technician should increase no load speed to
3,800±100 RPM by adjusting pressure switch.
• Severely clogged air filter. • Replace air filter.
• Improper lubrication. • Check for proper oil level.
Pump does not pump water
• Pump is not primed. • Prime pump.
• Intake strainer clogged. • Clean intake strainer or replace if damaged.
• Air leak at intake connector. • Replace coupling gasket or tighten clamp.
• Hose leaks. • Replace hose.
• Suction hose has collapsing wall. • Use hose with non-collapsible wall.
• Hose has too small diameter. • Use hose with diameter 2” or greater.
• Pump is too high above water surface. • Locate pump at a lower level so it doesn’t have to work so
hard to lift the water.
Low Pump Output
• Suction hose collapsed, damaged, • Replace or adjust suction hose.
too long or diameter is too small.
• Air leak at connector.
• Replace coupling gasket or tighten clamp.
• Strainer clogged. • Clean strainer.
• Discharge hose damaged, • Replace or adjust discharge hose.
too long or diameter too small.