13
Operating Instruction
⑤
DHCP ON/OFF
⑥
Apply: Click to confirm modified static IP
Note:When you click for DHCP ON,then IP Address,Net Mask Address,Gate Way Address frames all become
grey and can not be modified.
9. WEB Control
9.1 Change the IP address of your PC.
1). Connect the Ethernet port of HDBaseT switch to the Ethernet port on PC by a straight pin to pin
cable with RJ45 connectors.
2). Configure your PC as follows:
①
Click
Start
>
Control Panel
>
Network and Sharing Center.
②
Click
Change Adapter Settings
.
③
Highlight the network adapter you want to use to connect to the device and click
Change settings of this
connection.
3). The local Area commotion properties window for Network selection appears as below.
4). Click the Highlight
Internet Protocol Version 4 (TCP/IPv4)
.
5). Click
Properties
.
6). Select
Use the following IP Address
for static IP addressing and fill in the details.
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to 192.168.1.255 (excluding 192.168.1.168).
7). Click
OK
.
8). Click
Close
.
