Installation
Important: Please use the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Plug the 12V power adapter to the power jack of the transmitter. Ensure the
red LED for Power and green LED for Optic are lit.
Figure 2
– Connection of power adapter to the transmitter
Note:
You Must connect the power adapter to the transmitter even if the
graphic source provides enough power to operate the transmitter. Please,
refer to
AC/DC Power Adapter Technical Advisory
on page 1-2.
Step 3
Please, check if the maximum resolution of the display is UXGA (1600x1200).
Otherwise, follow the instructions for
Self-EDID Programming Procedure
on
page 1-5.
Step 4
Plug the 12V power adapter to the power jack of the receiver. Ensure the red
LED for Power and green LED for Optic are lit.
Figure 3
– Connection of power adapter to the receiver
1-3 Installation
Step 5
Connect LC optical fiber between the transmitter and the receiver as shown in
figure 4. ‘1’ of transmitter should be connected to ‘1’ of receiver and ‘2’ of
transmitter should be connected to ‘2’ of receiver by fibers.
Figure 4
– Connection of optical fibers
Note:
Both of single and multi-mode fibers are applicable up to 500meters. In
the case of longer than 500meters, you have to use single-mode fibers.
Step 6
Plug the transmitter to the DVI receptacle of the DVI source such as PC and
analog stereo audio.
Figure 5
– Connection of the transmitter to the DVI source
Note:
Be recommended NOT to use any intermediate cable or adapter between
them to avoid undesirable performance degradation.
Step 7
Plug the receiver to the DVI receptacle of the display and speaker.
Figure 6
– Connection of the receiver to the display
Step 8
Make the PC and the display power ON. Ensure that status LED is lit.
Note:
You can replace any DVI cable into an M1-203D-TR by following the
Step1
to
7
, while all powers of PC and display are ON.
1-4 Installation
