DIRECTV
HD
RECEIVER
USER
GUIDE
9
8
DIRECTV
HD
RECEIVER
USER
GUIDE
MODEL RC67L
These two buttons turn your TV and DIRECTV Receiver on or off together.
If your DIRECTV
System was installed professionally, your remote has already
been programmed to operate your TV. If you need to reprogram the remote
for a new TV or for any other reason, press MENU, select “Settings & Help”,
“Settings”, then “Remote Control”. Follow the step by step instructions.
*The remote control may vary by country and receiver model.
NOTE: Each time you press a button, a green light at the top of the remote flashes. If the light flashes
several times for just one press, it means the batteries (size AA) are getting low and need to be replaced.
TURNING YOUR EQUIPMENT ON AND OFF
MODEL RC64
REPLACING THE BATERRIES
1. Slide open the back of the remote control to remove the batteries.
2. Insert 2 new double AA batteries in the corresponding sides (po) and negative (-).
3. Slide the cover back when the batteries are in place.
PROGRAMMING YOUR CONTROL REMOTE (RC67L)
Option 1
1. Press and hold the MUTE and SELECT buttons at the same time until the green light at the top of your remote flashes twice,
then release both buttons.
2. Enter your TV programming code. If you don’t know it, you may look it up from the configurations menu.
Press MENU > Settings & Help > Settings > Remote Control > Program Control > TV.
3. Aim the remote at your TV and press the VOLUME UP button. If the volume doesn’t increase, repeat the steps with a different code.
4. If you have tried all the codes and it still doesn’t work, try to program the remote control with the automatic programming option.
Option 2
Follow these steps to scan for additional TV codes using your DIRECTV remote:
1. Press and hold the MUTE and SELECT buttons at the same time until the green light at the top of your remote flashes twice,
then release both buttons.
2. Using the number buttons, enter 9-9-1. The green light on your remote should flash twice.
3. Aim the remote at your TV and press the VOL button. The remote will send IR codes to your TV starting from the most commonly used.
4. If the TV responds, jump to step 5. If the TV doesn’t respond, press CHANNEL UP (CH UP). The remote control will try the next code.
Continue until the TV responds.
5. Press SELECT to record the code. The green light will blink twice.
PROGRAMMING YOUR CONTROL REMOTE (RC64)
When the MODE switch on your remote is in the left-most position, it controls your DIRECTV receiver. However, you can
also program the AV1, AV2 and TV positions to control other equipment such as your TV, DVD, VCR or Stereo.
Press MENU > Settings & Help > Settings > Remote Control > Program Control > TV. It is helpful to know the model number as
well as the brand of the equipment to produce the best results when programming the remote. To clear current AV1, AV2 and TV
settings use the “Reset Remote” option.
LH27_English.indd 8-9
12/3/13 4:33 PM
