DirecTV Advanced Installation Meter 2, Руководство по эксплуатации

Страница: 20 / 108

Page 20
AIM 2 Operation Manual
Power Management
Your AIM is powered by a 6-cell 10.8 Volt 4.4 Ah lithium-ion battery pack. The battery
supplies power to the meter, as well as to the LNB and SWiM during installation of an ODU.
When fully charged, the AIM’s battery provides sufficient power to install satellite receiver
systems in approximately six single-family homes on a single charge.
The AIM has the following power-saving features that help to extend the battery charge:
• If no buttons have been pressed on the AIM for 2 minutes, the backlight on the
display turns off. The backlight automatically turns back on when you press any
button on the meter.
• If no buttons on the AIM have been pressed for 10 minutes, the meter enters a
power-saving mode called Standby . The AIM automatically exits Standby mode
when you press and hold the
POWER
button until the backlight turns on.
If no buttons on the AIM have been pressed for 30 minutes, the meter automatically
turns off. To turn the meter on, press and hold the POWER button until the backlight
turns on.
• You can customize the time periods for each of the power-saving features on the
AIM (see Chapter 4: Setting Up the Meter). However, extending the time period
longer than the default setting shortens the time that the battery charge lasts.
You can quick press the POWER button to toggle the display
backlight on/off.
If you are using your AIM for the first time, you should fully
charge the battery before use. See the following Battery
Charging section.