DirectOut Technologies D.O.TEC ANDIAMO.AES, Руководство по оборудованию

Страница: 21 / 56

DirectOut Technologies
®
page 21 of 56 D.O.TEC
®
ANDIAMO.AES (SRC) Hardware Guide - Version 1.0
CHAPTER 4: Operation
© 2013 DirectOut GmbH
Blinking LEDs are also used to indicate an error (e.g. missing sync).
Concentrate on the section where one LED is blinking and the re-
maining LEDs are glowing weak.
Most settings can be adjusted either locally or via the remote ap-
plication (ANDIAMO Remote).
A few settings can be accessed via the remote application only:
• confi guration of the system fan control
• redundancy mode (only devices with two MADI I/Os)
• routing matrix
The settings are stored inside the device.
Menu Control
All functions of the converter can be accessed using a simple menu.
Two pairs of push buttons are used for navigation and settings.
The upper pair is used to confi gure the signal routing -
see „Menu
Navigation - Signal Routing” on page 38 [AES Version] or page
40 [AES SRC Version].
The lower pair controls the system settings - clock source, sample
rate, analog levels and MADI output format - see „Menu Navigation
- System Settings“ on page 42.
sElECt button
Press longer than 2 seconds to
enter the menu. Press short for
navigation in menu mode.
sEt button
Only active in menu mode. Press short
to adjust a setting. Press longer than
2 seconds to toggle the Matrix Mode.
When the menu mode is active a LED will blink in one of the sec-
tions while the remaining LEDs of this section are glowing weak.
This indicates:
• a setting can be adjusted in this section
• the blinking LED(s) is the selected option in this section
After a short period of time the menu mode is exit automatically.