P a g e
|
2
DSE976LY Rev 10/20
3)
Attach the two 3 x 4" sub boom plates to the angle brackets o
n the1/2” boom with the 8-
32 x 1/2
” hardware provided. Install the sub-boom to the two plates with the two mast plate
mounting holes offset towards the rear (for mechanical balance). Use the 8-32 x 1 1/4"
machine screws. Install the mounting plate with the remaining 8-
32 x 1 1/4” screws. Install the
1 1/2" U-bolt in the holes provided.
4)
Attach the feed line and tape it to the bottom of the boom & sub-boom. The connector
should be sealed with silicone RTV or equivalent. On quad arrays it is possible to install the
power divider near the driven elements suspended from the short semi rigid phasing lines and
the hardline feeder.
5)
The antenna SWR has been adjusted at the factory for less than 1.5:1 VSWR.
Additional tweaking can be accomplished by changing the shape of the driven element slightly
and by adjusting the distance between the driven element andR1 and D1. R1 is the reflector
closest to the driven element.
NOTE:
Do not attempt this adjustment unless the proper
equipment and qualified personnel are available.
6)
If antennas are to be stacked, see "Instructions for Stacking Loop Yagis".
DO NOT, UNDER ANY CIRCUMSTANCES, APPLY ANY TYPE OF SEALANT OR COATING TO THE
DRIVEN ELEMENT, T-ARMS OR CONNECTOR ASSEMBLY, OTHER THAN KRYLON
®
CLEAR COAT. ANY OTHER COATING WILL ADVERSELY AFFECT THE SWR AND VOID YOUR
WARRANTY.
Directive Systems Warranty Policy
All Directive Systems antennas are built with the finest materials available. We take great pride
in building a quality product that will give years of good service and performance. If there is a defect
in materials or workmanship within 90 days of purchase, Directive Systems will repair or replace
the defective part, free of charge, to the original purchaser.
DO NOT RETURN ANYTHING
WITHOUT PRIOR AUTHORIZATION FROM DIRECTIVE SYSTEMS
. Please contact us either by
phone or email describing the problem and we will work to resolve it.
If, after examining a new antenna you received, you are not satisfied, contact us immediately
for return authorization and refund.
ANY ANTENNA THAT HAS BEEN MODIFIED WILL BE
SUBJECT TO A RESTOCKING CHARGE. IF AN ANTENNA IS SO MODIFIED AS TO MAKE IT
UNUSABLE, DIRECTIVE SYSTEMS RESERVES THE RIGHT TO REFUSE TO ACCEPT THE
ANTENNA FOR RETURN.
