2
© 2012 Directed. All rights reserved.
To start the vehicle using the factory key fob, press the panic button once for ½ sec-
ond and release. The vehicle parking lights will flash once to confirm and then the
engine will start within 5 seconds. Once the engine has started the parking lights
will flash once every 5 seconds. The starter system will continue to run the engine
for 15 minutes. After 15 minutes the vehicle will shut down. The vehicle can be
remote started up to 5 times between normal key or push button start operation.
To shut down the vehicle engine, press the panic button again.
To perform driver takeover, insert the key into the ignition and turn to the ‘RUN’ po-
sition. The parking lights will flash three times to indicate that the XPRESS
START
has
shut down but the engine will remain running. For vehicles equipped with Keyless-
Go (push-to-start) function, press the ‘START’ button once. The parking lights will
flash three times to indicate that the XPRESS
START
has shut down but the engine
will remain running.
The vehicle security system remains intact while the engine is remote started. The
KeylessGo and key fob locking and unlocking will still function and the gear shift
will remain locked until either a valid key is inserted into the ignition or the ‘START’
button is pressed while a valid key is present in the vehicle. If the foot brake is
depressed or the hood is opened while remote started, the engine will immediately
shut down.
Troubleshooting
:
When the remote start function terminates, the parking lights will flash a specific
number of times to indicate the reason for shutdown:
3 flashes: Normal Shutdown
5 flashes: Exceeded maximum number of remote starts
6 flashes: Foot brake was depressed
7 flashes: Hood opened
8 flashes: Engine RPM too high
9 flashes: Engine failed to start
10 flashes: Communication Error
If you encounter any problems, the vehicle and remote starter system can always be
reset using the following procedure:
1. Turn off ignition
2. Close doors and lock with the factory key fob
3. Wait 5 minutes
4. Unlock doors with factory key fob
5. Insert key into ignition and start vehicle
6. Wait 1 minute
7. Turn off ignition
QRGMBRS 2012-10
