10
© 2003 Directed Electronics, Inc.
REMOTE CONTROL BATTERY
■
Battery Installation
■
Press on the panel at the rear of the
remote control and slide the battery
cover open.
■
Insert the batteries while observing
the correct (+) and (-) polarities.
■
Slide the battery cover into place on
the back of the remote control.
■
Service life of batteries - The batteries nor-
mally last for about six months, although
this depends on how often the remote
control is used.
■
If the remote control until fails to work,
even when if is operated near the player,
replace the batteries.
■
Use size AAA batteries.
■
Do not drop, step on, or otherwise impact
the remote control unit.
■
Do not mix old and new batteries.
■
If the remote control is not going to be
used for a long time, remove the batteries.
REMOTE CONTROL OPERATION RANGE
This unit is supplied with an external remote sen-
sor which allows you to access all features by
remote control when the DVD unit is mounted in
a location where the DVD is out of the line of
sight.
The remote control should not be used from
more than about 23 feet (7m) from the remote
control sensor and within about 60 degrees of
the front of the payer. The operating distance
may vary according to the brightness of the
vehicle interior.
PRIOR TO USE
■
The player output signal must be adjusted
to match the monitor system type. Press
the
SYSTEM
(22) button to change the sys-
tem output signal type as shown.
■
During playback, the TV volume may be at
a lower level than other source units. If
this is the case, adjust the volume to the
desired level.
■
Select the appropriate screen type from
the setup menu according to your monitor.
■
Connect the DVD player according to the
instructions in the
Installation
section of
this guide.
■
If the DVD player is connected to the mon-
itor through a VCR, the picture may not be
played back normally. It is strongly recom-
mended not connecting the DVD player
through a VCR.
■
The on-screen menu language of your play-
er has been factory preset to English. If
you would like to change the menu lan-
guage, please refer to the
Setup Menu
sec-
tion of this guide.
■
Check the following before using the DVD
player:
■
The monitor and audio equipment are
properly connected to the player.
■
The power for the monitor and audio
equipment is turned on.
■
The input setting for the monitor and
audio equipment is properly selected.
Remote Operation
N83102 1-03.qxd 5/6/2003 8:33 AM Page 10
