Directed Electronics CLIFFORD 320.3X, Руководство пользователя

Страница: 29 / 41

26 © 2009 Directed Electronics. All rights reserved.
Out of Range
Each time a command is performed the Responder LE will expect a
command confirmation from the system. If a command confirmation
is not received the
and transmit LED’s flash and a long fault tone
plays as an alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or out of range output. This
indicates that the system received the command but it was an incom-
plete command (e.g. aux button pressed too short to activate the trunk
release) or it was an illegal message (e.g. the command was cor-
rupted due to local RF interference). These are temporary normal func-
tions of the system and remote, perform the command again within 10
seconds to return to normal operation.
Car Select
Car 2 must first be turned on (See Remote Control Configuration sec-
tion to turn on).
Press
1. and
hold
the button for 3 seconds. The remote flashes
the transmit LED and beeps once or twice to indicate the selected
car is 1 or 2.
Release
2. the button for car select or continue to
hold
for program-
ming.
Release
3. the button, then
press
and
release
while the transmit
LED and beeps continue to perform car select. Once the car is
selected a command can be performed by pressing one of the
command buttons.
Note:
The 1-way remote does not emit any indication beeps. The
transmit LED flashes once or twice to indicate car one or car two.