User guide
P.5
To set the system to Ready Mode:
If Ready Mode is enabled by remote
If Ready Mode is enabled by handbrake
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2.
With the engine running, apply the parking
brake once and release the brake pedal.
3.
Within 20 sec. of engaging the parking
brake, press and hold on the transmitter
(SmartStart™ uses only the SmartStart™
icon).
The parking lights will flash 3 times quickly
and remain lit. Release the button.
2.
With the engine running, apply the parking
brake twice within 10 sec.
3.
Make sure to release the brake pedal.
The parking lights will flash 3 times quickly
and remain lit.
4.
Remove the key: the engine will keep on running.
5.
Exit the vehicle. All doors should be closed, including the hood and trunk.
THERE ARE THREE POSSIBLE OPTIONS TO COMPLETE READY MODE (programmable
by installer)
OPTION 1: Automatic shut
down without auto lock
OPTION 2: Manual shut
down
(default)
OPTION 3: Automatic shut
down with auto lock
The engine runs for 8 sec.
before finally shutting down
the engine, without user
interaction.
The engine keeps going until you
press either;
a.
to lock the doors and
shut down the engine (if
option 1 was programmed);
•
to shut down the engine
without affecting the doors (if
option 2 was programmed).
The engine runs for 8 sec.
then locks the doors before
finally shutting down the
engine, without user
interaction.
WARNING: The vehicle is
not armed or locked down.
WARNING: Engine runs until the
pre-programmed run time
expires.
WARNING: Do not leave
your keys in the vehicle!
6.
The Parking lights will flash twice to indicate Ready mode is set.
Remote
starting
Press the
button for approximately 1 second. The parking lights will turn ON to inform you that
the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain ON during the pre-programmed run time of the engine.
If your vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Driving
Off
With the vehicle running remotely, press the
button (ONLY if programmed as the LOCK or
UNLOCK button) to disarm the starter kill (if installed) and unlock the doors. Enter the vehicle and
do the following:
1.
Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
