2
© 2002 Directed Electronics, Inc. Vista, CA
N795T 8-02
The 795T is a multi-channel paging system that uses
EEPROM to learn the code of the base unit. Please
take time to read this installation guide prior to
installing the unit.
Electrical Connections
NOTE: Make all electrical connections prior to plug-
ging the main wiring harness into the base unit.
RED (+) 12V Constant Power Input
- Connect this
wire to the positive battery terminal or to a good 12V
source at the ignition harness.
WHITE, WHITE/BLACK Power Antenna Interface
-
(+ 200mA capable) These wires are used to raise the
factory power antennas.
BLACK (-) Chassis Ground
- Connect this wire to a
paint-free metal surface. If possible use a factory bolt
as it will resist stripping when tightening.
Orange (-) Ground-When-Armed Input
- Connect to
the ground when armed output of the security system. If
your security system does not have a ground when armed
output, then use the brown (+) siren wire in it’s place.
NOTE: If connecting the orange wire to control
another module a 1 amp diode (type 1N4004)
will be required. (See the below diagram.)
GREEN (-) Zone 3 Door Input
- Connect to the (-)
door trigger input of the security system.
BLUE (-) Zone 1 Input
- Usual connections are either
the shock sensor trigger wire, hood trigger wire, or
trunk trigger wire.
GRAY (-) Zone 2 Input
- Usual connections are either
the shock sensor, WarnAway
®
wire, or a field distur-
bance sensor trigger wire.
BROWN (+) Siren Input
- This wire connects to the
positive siren wire of the security system ONLY if the
security system does not offer a (-) ground when
armed output.
VIOLET (+) Zone 3 Door Input
- Connect to the (+)
door trigger input of the security system.
NOTE: Once the wires have been connected to
inputs of the alarm, make note of these con-
nections for future reference.
AM/FM Antenna
- Unplug the antenna from the radio
in the car and plug it into the port on the base unit
marked ANTENNA. Then plug the supplied antenna
cord into the port marked RADIO and also into the
back of the radio in the vehicle.
The 795T receiver is code learning. Before attempting
to teach the unit a code, the manual paging switch
pod must be plugged into the base unit.
1. Press down on the ON/OFF switch on the pager
unit and hold it down. While holding, slide the
power switch to the ON position. Both LEDs will
code learning
installation instructions
