© 2005 Directed Electronics, Inc. all rights reserved www.directed.com
2
2005 model Directed Audio Amplifiers have been designed with a custom heat sink that accomodates two (optional - not supplied) LED lightbars. Use the following proce-
dure for installation in Directed Audio Amplifiers.
1. Remove the LED tubes, find the connection points to the LED tubes and the plug which connects to the amplifier.
2. Slide each LED tube assembly into your Directed Audio Amplifier heat sink. Ensure the wire harness is on the same end of the amplifier where the plug connects to
the amplifier (signal input end). Orient the LED tube assembly so that the LEDs are facing out for optium lighting effect.
3. Connect the 4-in plug to the LED/FAN input port of the Directed Audio Amplifier.
NNOOTTEE 11:: The other RED and BLACK wire can be connected to an optional fan. The fan must not draw more than 200mA. If the optional fan is not being used, the ends
of these wires must be insulated to prevent shorting and subsequent damage to the amplifier.
NNOOTTEE 22:: The other RED and BLACK wire can also be used to drive the second tube to increase the lighting intensity. Simply cut the existing harness to separate one of
the two tubes from the pre-wired plug, and splice it to the RED and BLACK fan wires.
LED LIGHTBAR INSTALLATION
Material: Polycarbonate/Acrylic
Quantity 2 Lightbars
Finish: Translucent/Clear
Current Draw: Model DIRW9BL 125 mA
LEDs: Gallium Arsenide/Gallium Nitride
Model DIRW15BL 250 mA
Voltage: 12 VDC
Lifetime: 100,000 hours
SPECIFICATIONS
WIRING DIAGRAM
LED Lightbar
Connector
to Amplifier
Optional
Fan (200 mA max)
Optional Cut - see note 2
Optional - connect 2nd LED tube
to fan leads - see note 2
