Directed Audio 150, Руководство пользователя

Страница: 9 / 12

7
© 1999 Directed Electronics, Inc
CROSSOVER SETTINGS AND GAIN ADJUSTMENT
Your Directed Audio power amplifier needs to be adjusted carefully to achieve
maximum performance. These are some guidelines to follow when fine-tuning the
amplifier.
• For full-range and simultaneous stereo/mono bass applications, the crossover selection
switch should be set to "FLAT". If the amplifier is driving your subwoofers, set the
switch to "LPF", and for mid-bass/midrange output, set to "HPF".
• The crossover frequency control needs to be adjusted to suit your particular system.
For subwoofer applications, try and keep the setting low enough to prevent image
smearing (you should not be able to hear male voices from the subwoofer) but not so
low as to create a gap between the subwoofer and the mid-bass/midrange speakers.
For mid-bass/midrange settings, try to keep the setting low enough to keep your
sound stage in front of you, without overdriving the speaker. It will be to your advan-
tage to spend some extra time with this adjustment, listening to familiar music or
system set-up discs to achieve the kind of musical reproduction that you prefer.
• The gain adjustment allows you to set proper signal match for clean, quiet amplifier
operation. For full-range and simultaneous stereo/mono bass applications, start by
playing some music you are familiar with. With the gain adjustment on the amplifier
in the middle of its rotation, bring up the volume on your head unit to the 3/4 volume
setting or until you start to hear distortion or clipping. If you hear distortion before you
reach the 3/4 volume setting of your head unit, reduce the gain setting on the ampli-
fier and start to raise the head unit volume again. When you can listen to the music
at or slightly above 3/4 on your head unit without audible distortion, slowly raise the
gain of the amplifier until distortion is heard, then back off the gain until the distortion
is not audible. This setting will allow you to reach full output with all but the quietest
of source material, while avoiding excessive noise in the system.
• The same procedure should be used for adjusting the amplifier when the on board
crossover is set to LPF or HPF, but you will also have to take into consideration the
effect that gain adjustment has on system frequency response and imaging. Again,
plan on spending some time with music that you know getting the gain and crossover
settings the way you like. Test discs and analyzers may help with this process, but in
the end it's your ears that count - listen to the music !