Directed Audio 1100d, Руководство пользователя

Страница: 13 / 20

13
© 2002 Directed Electronics, Inc
1. IInnppuutt SSiiggnnaall - Connect these RCA
jacks as described in the Front Panel
Connection section of this guide.
2. SSllaavvee//M Maasstteerr SSw wiittcchh
„
Set the slave/master switch
on the master amplifier to the
MASTER position.
„
Set the slave/master switch
on the slave amplifier to the SLAVE
position.
„
Setting the slave/master
switch on both amplifiers will auto-
matically set the I/O RCA jack
configuration according to each
amplifier’s slave or master designa-
tion.
NNOOTTEE:: One master amplifier can control up to three slave
amplifiers in this combination. Multiple identical
master/slave combinations can be added to any
given system.
3. RReem
moottee SSuubb LLeevveell CCoonnttrrooll - Connect
the Remote Sub Level Control to the
master amplifier only. The master
amplifiers subwoofer gain is used to
set the overall gain for all synced
amplifiers, then the Remote Sub
Level Control can adjust the gain of
all synced amplifiers.
4. SSiiggnnaall CCoonnnneeccttiioonn - Connect an RCA
cable between the SYNC OUT RCA
jack of the master amplifier and the
SLAVE IN RCA jack of the slave
amplifier as shown in the Figure 5.
5. SSuubbw wooooffeerr SSppeeaakkeerr CCoonnnneeccttiioonn - In
this amplifier combination each
amplifiers must drive its own sepa-
rate subwoofer(s). Connect the
speaker terminals of each amplifier
to any combination of one or more
subwoofers that results in nominal
impedance between one and four
ohms. Make sure that each amplifier
sees the same speaker impedance.
PARALLEL SYNCED GAIN CONNECTIONS/SETTINGS