15
403.FORD18 1.06 2021 Lincoln Nautilus (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
Parking light error codes
The parking lights on your vehicle will flash a specific number of times 3 seconds following an unscheduled shutdown. Each
flashing pattern is described below.
Flashes Diagnostic
1
Runtime expired.
2
Over-rev shutdown.
3
Low or no RPM.
4
Shutdown without remote.
5
Brake shutdown.
6
Hood shutdown/Remote start safety override switch is ON.*
7
Remote start safety override switch is ON.*
* If the vehicle hood status is supported through data, the safety override switch input will report 7 flashes.
Soft reset
1
Connect
the 10-pin & 12-pin harnesses to the module.
Press
and
hold
the
programming button, then
connect
the 14-pin harness to the module.
4
th
(14-pin)
3
rd
(Button)
1
st
(10-pin)
2
nd
(12-pin)
2
Wait
3 seconds until the LED turns ON solid orange then
release
the programming button.
The LED turns ON solid red.
&
&
Solid
Solid
Release
A module reset will only erase the steps perfomed in “Module programming”. The firmware and settings flashed to the module
will not be affected.
Hard reset
Warning Against Executing a Hard Reset!
1
Connect
the 10-pin & 12-pin harnesses to the module.
Press
and
hold
the
programming button, then
connect
the 14-pin harness to the module.
4
th
(14-pin)
3
rd
(Button)
1
st
(10-pin)
2
nd
(12-pin)
2
Wait
3 seconds until the LED turns ON solid orange, and
wait
10 more seconds until the
LED starts to flash orange and red.
Solid
Flashes
&
3
Release
the programming button. The LED turns ON solid red.
&
Release
Solid
A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings (such
as RFTD and D2D options) may have to be reconfigured. Refer to “Feature and option list”.
