Direct Supply Attendant Series, Руководство пользователя, Страница: 6 / 12

6
Cleaning
Cleaning
It is recommended that the nebulizer and mouthpiece are thoroughly cleaned with
hot water after each use and cleaned with a mild detergent after the last treatment
of the day. If your physician or respiratory therapist specifies a different cleaning
procedure, follow their instructions.
Cleaning Notes:
a) Do not immerse the unit in water. It may damage the unit.
b) Disconnect the unit from the electrical outlet before cleaning.
c) Clean all necessary parts after each use as instructed in this guidebook.
Rinsing (after each treatment):
Step 1: Disconnect the air tube, nebulizer and mouthpiece.
Step 2: Gently twist the nebulizer to open it.
Step 3: Rinse the nebulizer and mouthpiece with water.
Step 4: Dry them with clean soft towel or let air dry.
Step 5: Reassemble the nebulizer when completely dry and put these parts in a
dry, sealed container.
Disinfections:
Please follow the following steps to disinfect your nebulizer unless otherwise
specified by your physician. It is suggested that the unit is disinfected after the last
treatment of the day.
Step 1: Use one part white vinegar with three parts distilled water. Make sure
mixed solution is enough to submerge the nebulizer, mouthpiece.
Step 2: Complete above Rinsing Steps 1-3.
Step 3: Wash the nebulizer, mouthpiece in warm water and a mild detergent. Then
wash them in hot tap water.
Step 4: Submerge these parts in the vinegar and water solution for 30 minutes.
Step 5: Complete above Rinsing Steps 3-5.
Cleaning the Compressor:
Step 1: Wipe daily with a damp cloth.
Step 2: Do not use any powdered cleaners or soap pads, which may damage
the finish.
Filter Change:
Step 1: Do not use cotton or any other materials. Do not wash or clean the filter. Only
use filters supplied by your distributor. And do not operate without a filter.
Step 2: Change the filter every 30 days or when the filter turns gray.
Step 3: Changing procedure:
a) Remove the filter cover.
b) Replace the used filter with a new one.
c) Replace the filter cover.