See Fig 3. If the SDS tool is not located repeat the
installation operation again.
6. OPERATING THE ON/OFF SWITCH
Holding the Rotary Hammer with both hands
and press the single speed on/off switch in for
operation (see Fig 4), release switch to stop.
WARNING!If the hammer/drill selector
can not go into position, turn the
gearbox.Before operating, select required
mode by aligning symbol on switch with
arrow. And ensure selector is positioned.
It could cause a hazard if the selector
switch is not firmly locked.
Note: Press the dial selector lock before
adjusting the dial selector anytime.
7. HAMMER DRILL FUNCTION
1 Adjust the lever selector to position
“
“ to provide the hammer action (see Fig 5)
2 Adjust the dial selector to position
“
“ to provide rotation of the chuck (see Fig 6)
3 you are now set up for drilling into masonry.
8. CHISEL FUNCTION
1 Adjust the lever selector to position
“
“ to provide the hammer action (see Fig 7)
2 Adjust the dial selector to position
“ “ to stop rotation of the chuck (see Fig 8)
3 you are now set up for chisel work using
hammer action.
To fit a chisel bit, see
FITTING SDS TOOLS OR
CHUCK
on page 9. The chisel will be gripped
firmly by its shank.
9. DRILLING FUNCTION
1 Adjust the lever selector to position
“ “ to stop the hammer action (see Fig 9)
2 Adjust the dial selector to position
“
“ to provide rotation of the chuck
(see Fig 10)
3 you are now set up for chisel work using
hammer action.
10. USING THE DEPTH GAUGE:
1. Rotate the handle anti-clockwise, insert depth
gauge into the handle (see Fig 11).
2. Adjust the depth gauge to desired depth.
Fig 6
Fig 7
Fig 8
Fig 9
Dial
selector
lock
Dial
selector
Содержание BH26S3
Страница 1: ...5kg SDS Plus Rotary Hammer Drill BH26S3 SAFETY AND OPERATING MANUAL...
Страница 15: ...5kg SDS Plus Rotary Hammer Drill BH26S3...
Страница 16: ......