Wash Cycle Table
Cycle
Eco
Button
RAPID
Button
Cycle Selection
Information
Desciption of
Cycle
Deter-
gent
Rinse
Aid
Normal Wash
6
Normal Wash
Light Wash
6
Rinse
Glassware
Glassware
Soak
Normally dirty dishes,pots
and pans.Standard daily
cycle.
Very dirty dishes,pots and
pans.(not to be used with
delicate items)
Normally dirty dishes,pots
and pans without dried on
residue.
For dishes that need to be
rinsed and dried only.
Economic,fast cycle to be
used for items which are sen-
sitive to higher.Run immedi-
ately after dishes are used.
Economic,fast cycle to be
used for items which are sen-
sitive to higher.Run immedi-
ately after dishes are used.
Pre-wash of dishes, pots and
pans while waiting for the load
to be complete after the sub-
sequent meal
.
Pre-wash with hot water.
Extended wash at 65
Rinse with cold water.
Rinse with hot water at 70
Drying.
Pre-wash with cold water.
Extended wash at 55
Rinse with cold water.
Rinse with hot water at 70
Drying.
Extended wash at 65
Rinse with cold water.
Rinse with hot water at 70
Drying.
Rinse with cold water.
Rinse with hot water at 70
Drying.
Wash at 55
Hot Rinse at 65
Drying.
Wash at 55
Rinse with cold water.
Short cold wash to pre-
vent food residue from
drying on the dishes
30g
30g
25g
15g
15g
.6.
Turning on the Appliance
Starting a wash cycle
- Make sure that the plug for the appliance is inserted into the wall
socket.
- Make sure that the water supply is turned on to full pressure.
- Load the dishwasher (see the section entitled,"Loading the
Dishwasher").
- Pour in the detergent (see the section entitled,"Salt,Dergent and
Rinse Aid").
- Turn the knob located on the right of the control panel in the
clockwise direction until the number or symbol for the cycle set
ting is aligned with the reference mark(see the section entitled,
"Wash Cycle Table").
- Press the ON-OFF botton,and the ON-OFF light will turn on.At
this point,the wash cycle will begin.
Cancelling or modifying a wash cycle setting
Premise:A cycle that is underway can only be modified if it has
only been running for a short time.Otherwise, the detergent may
have already been used,and the appliance mayhave already
drained the wash water>If this is the case,the detergent dispenser
must be refilled(see the paragraph entitled,"Loading the
Detergent").
Press the ON-OFF button,and the ON light will turn off.Rotate
the knob in the clockwise direction to the desired cycle setting
(see the section entitled.:Starting a wash cycle
If you forget to load some of the dishes
The wash cycle can be interrupted by pressing the ON-OFF button.
You can then load additional dishes and turn the appliance back
on.The cycle will start where it left off.
Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more
susceptible to breakage.They will also dry better.
Wash Cycle Adjustment Buttons
"ECO" Button
This button(see "close-up View - Control Panel",letter"G")is used
for the normally dirty dishes,pots and pans.It is standard daily
cycle.
"1/2 load" Button
This button(see "close-up View - Control Panel",letter"H") make
it possible to wash dishes using only the upper rack if there are
not enough dishes for a full load.This will allow you to save on
water and eletrical energy.
"Rapid" Button
This button(see "close-up View - Control Panel",letter "I") ,when
pressed with wash cycle 4(glassware) make it possible to run
the wash cycle at a lower temperature
(50
) and eliminates the drying phase.
It can be used before setting any of the wash cycles, except for
the intensive cycles (if included in the wash cycle table ). Please
keep in mind that the amount of degertent should also be cut in
half.
Important: In general, it is not advisable to open the door
while the machine is working. Care must be taken if the
door is opened during the hot phase or immediately after a
program has finished as steam may escape.
1
4
3
2
5
.7.
At the end of the wash cycle
When the knob stops turning (see figure), the cycle has finished.
When the washing program has finished ,it is recommended that
the dishwasher is unplugged and the water is turned off.
