ICS-90 Installation Instructions
24
Doc. 031856-03 12/06
For additional information, refer to the
Installation Instructions and
Troubleshooting Guide for the Displacement Chemical Regeneration
(DCR) Kit
(Document No. 031664). The manual is included on the
Dionex Reference Library CD-ROM (P/N 055405), located in the ICS-90
Ship Kit.
4. Make sure the regenerant reservoir is filled almost to overflowing.
5. Slip the air regulator accessory bracket over the neck of the eluent reservoir.
6. Install the caps on the eluent and regenerant reservoirs and hand tighten.
7. Place the reservoirs in the holders on the top cover of the ICS-90.
8. Connect the liquid lines from the ICS-90 to the lines exiting the eluent and
regenerant reservoir caps (see
) as follows:
a.
Connect the two lines labeled
Eluent Bottle Out
.
b. Connect the two lines labeled
Regen Bottle Out
.
c.
Connect the line labeled
Regen In
to the green
Regen Bottle In
line from
the ICS-90.
Figure 2-15. Reservoir Connections
Gas Inlet Line
(from gas source)
Eluent Gas
Line
Regen Bottle
In Line
Regen Bottle
Out Line
Eluent Bottle
Out Line
