Dionex ASE 100, Руководство оператора

Страница: 57 / 150

3 • Operation and Maintenance
Doc. 031842-01 5/02
3-25
3.6 Aborting a Run
To abort a run manually, press the
STOP
button. This stops the run and displays
the
ABORT
screen (see Figure 3-12).
The
ABORT
screen presents two options (see below). Move the cursor to the
preferred option and press
ENTER.
The ASE 100 contains built-in diagnostics and sensors that continuously monitor
the system. Under certain conditions (for example, if the collection bottle
becomes too full or if the hydrocarbon vapor level exceeds the upper limit), the
system will automatically abort a run. If this occurs, the ASE 100 screen will
display an error message; the message will remain on-screen until you press a key
to clear it or until it is replaced by another error message. For a list of error
messages (and corrective action to take), see Section 4.1.
NOTE After a run is aborted (whether manually or
automatically), rinse the system before resuming
operation. For instructions on how to run a rinse cycle,
see Section B.2.6.
Figure 3-12. Abort Screen
Option What it means:
ABORT
METHOD Cancels the method. If necessary, a purge is done to
remove solvent from the sample. Then, residual
pressure is relieved from the system.
CONTINUE
METHOD Resumes the run from the point at which the STOP
button was pressed.