Dion-Ag Scorpion 300, Руководство оператора

Страница: 65 / 109

SETUP
65
TRANSPORT LIGHTS
FIGURE 73
The transport lights on the right-hand side can be raised to reduce the harvester overall width when storing
he machine or circulating in narrow spaces. To raise, remove the pin (item 1 configuration 2), then raise the
light assembly and reinstall the locking pin (item 1 configuration 3).
The lights can also be adjusted to two different positions on both sides. Generally, regulations require that
the extremity of the light be less than 40cm (16in) from the outermost edge of the harvester, including the
header, in transport position. Check with your local authorities for the applicable requirements.

On the left-hand side, unbolt the support and move to the next set of holes.

On the right-hand side, an extension bar is provided with the light package to obtain the extended
position that may be required depending on the header width. Make sure the red lights and reflectors
are located on the back side.
Figure 73 Transport light configuration
STOPPING THE MACHINE
It is essential to be familiar with the controls and safety rules. It is essential to know how to stop the
machine before starting it. Refer to page 70, section «STOPPING THE HARVESTER».
Manual N o. F6918E003E v1.2