(314) 205-3033
WWW.DIODEDYNAMICS.COM
PAGE 2
PP0132
Please contact
Diode Dynamics
should you have any questions about the installation
or wiring process, at
314-205-3033
(9a-5p CST) or
2. Using a trim removal tool, remove the eight push
rivets along the front of the splash guard. We
recommend prying on both accessible sides of the
push rivets at the same time due to their large size.
Remove the splash guard. To do so, use an 8mm
socket and ratchet to remove the two bolts on the
bottom of the splash guard.
WARRANTY
3 YEAR
This installation guide is for the following SKUs:
DD6576
Worklight SS3 Sport Type MS Kit White Driving
DD6577
Worklight SS3 Sport Type MS Kit White Fog
DD6578
Worklight SS3 Sport Type MS Kit Yellow Fog
DD6579
Worklight SS3 Pro Type MS Kit White Driving
DD6580
Worklight SS3 Pro Type MS Kit White Fog
DD6581
Worklight SS3 Pro Type MS Kit Yellow Fog
3. Remove the plastic fog light covers. To do so, use a
7mm socket and ratchet to remove the seven screws
shown in the picture to the left.
4. Remove the factory fog light assembly. Use a
T20 Torx driver to remove the three screws. We
recommend using hand tools to reduce the chance
of thread stripping or heating of the plastic that
may occur with power tools.
These screws will be reused.
GUARANTEE
100% SATISFACTION
8
year
warranty
5. Using the three original torx screws, install the SS3 and bracket onto the vehicle. Ensure
the lamps are oriented such that the DT connector is on the “bottom” of the lamp and the
SAE markings are readable when installed on the vehicle.
6. Plug the SS3 into the factory fog light harness using the included DT wire adapter.
Test function. If the light does not turn on, try flipping the connector 180°.
7. Adjust and aim the fog light according to your local and state laws. To adjust, loosen the
screws on the sides of the bracket, aim, and re-tighten. In general, fog lamps should be
angled slightly downwards to illuminate the area directly in front of the vehicle, below
your headlamps.
8. Reinstall the fog light covers and splash guard to complete the installation.
Please contact
Diode Dynamics
should you have any questions about the installation
or wiring process, at
314-205-3033
(9a-5p CST) or
