Dinli DL-801, Руководство по обслуживанию

Страница: 91 / 122

【
6-36
】
ENGINE
●
Measure the crankshaft run out (A).
Service Limit
: 0.10mm replace if over
●
Measure the connecting rod big end side clearance (B).
Service Limit
: 0.6mm replace if over
●
Measure the connecting rod big end radial clearance (C).
Out of specification (0.05 mm) – Replace the crankshaft.
●
Turn the crankshaft bearings and check for excessive play.
●
Measure the crankshaft bearing play.
Pitting/wear/damage – Replace
CRANKCASE/BALANCER INSTALLATION
●
Install the balance shaft and crankshaft into the left
crankcase.
NOTE:
Align the mark on the balance shaft with the mark on the
crankshaft
●
Install the dowel pins and new gasket.
●
Install the right crankcase and tighten the crankcase attach
bolts.
●
Install the timing chain.