DINGLI SL1323-AWD, Руководство оператора, Страница: 31 / 73

OPERATOR’S MANUAL with Maintenance Information
Function Tests
27
blue arrow on the control panel until the
machine begins to move, then return the
proportional control handle to the center
position.
⊙
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
39 Press and hold the function enable switch
on the proportional control handle.
40 Slowly move the proportional control
handle in the direction indicated by the
yellow arrow on the control panel until the
machine begins to move, then return the
proportional handle to the center position.
⊙
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
Test Limited Drive Speed
41 Press the lift function select button. Raise
the platform approximately 3 m from the
ground.
42 Press the drive function select button.
43 Press and hold the function enable switch
on the proportional control handle slowly
move the proportional control handle to the
full drive position.
⊙
Result: The maximum achievable drive
speed with the platform raised should not
exceed 31cm/s.
¤
Result: If the drive speed with the platform
raised exceeds 31cm/s, immediately tag
and remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with
the platform controller. Do not stand in the
platform.
44 Fully lower the platform.
45 Drive both wheels on one side onto an
12cm block.
46 Raise the platform approximately 3.0 m
from the ground.
⊙
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute.
The platform controls LED readout should
display LL.
47 Press the drive function select button.
48 Press and hold the function enable switch
on the control handle.
49 Move the proportional control handle in the
direction indicated by the blue arrow, then
move the proportional control handle in the
direction indicated by the yellow arrow.
⊙
Result: The drive function should not work
in either direction.
50 Press the lift function enable button.
51 Lower the platform and drive the machine
off the block.
Test the Up Limit Switch and the
Outriggers (for SL1623-AWD)
Note: Perform this test from the ground with
the platform controller. Do not stand in the
platform.
52 Press and hold the function enable switch
on the proportional control handle. Raise
the platform.
⊙
Result: The platform should rise to 9 m and
then stop. The platform should not rise
above 9 m unless the outriggers are
lowered.
53 Press the drive function select button.
Drive the machine forward.
⊙
Result: The drive function should not
operate.
54 Press the lift function select button.
55 Lower the platform. If the platform is higher