Dinel ULM-53 series, Инструкция по эксплуатации

Страница: 16 / 28

UL_–53
©
Dinel, s.r.o.
16
12 . S
ETTiNg
Fig. 33: Default mode
(level measurement)
The level meter works most often in its default mode for level measurement (Fig. 33) and only rarely
in the inverse mode (Fig. 34).
The manual device shall be set up after installation using the DOWN and UP buttons (for version
“T”) or by applying the magnetic pen onto sensitive flat areas (for version “M”). The set-up process
is indicated by the STATE indicator lamp.
The L version level meter does not have any setting controls and indication LEDs. Pre-defined
ranges are factory set (applicable to current and voltage outputs).
The level meter variant with a Modbus type output is set by means of two-way communication via
the RS-485 industrial bus with the Modbus RTU protocol. A list of applicable registers is given in a
separate appendix. To set up the level meter and collect measured data, you can use the software
application „Basic SCADA level“, which is freely available at the Website www.dinel.cz.
Fig. 34: Inverse mode