INSTALLATION INSTRUCTIONS
PREPARATION
The heater will arrive
separately from its
storage bricks, the
following bricks will
be required.
Model 712N - 8 bricks
Model 718N - 12 bricks
Model 724N - 16 bricks
WARNING
- This appliance must be earthed.
Only heat resisting cable (min. rating T85) should be used. The
wires in the mains cable will be coloured as follows;
GREEN & YELLOW
-
EARTH
BLUE
- NEUTRAL
BROWN
- LIVE
SUGGESTED FIXINGS
SOLID BRICK/BLOCK
- No. 10 size plastic inserts, 8mm drill bit.
Drill hole 15mm deeper than plastic insert length.
PLASTERBOARD
- If possible locate studding and use No. 10
woodscrews directly into the wood, otherwise M5 rawlplug intersets
are suitable.
NOTE:FOR ALL OTHER WALL TYPES
(e.g. Timber frame and
hollow concrete)
SEEK SPECIALIST ADVICE.
FIXING ASSEMBLY
1. ENSURE THAT FIXING KIT AND FEET HAVE BEEN LOCATED
BEFORE DISPOSING OF PACKAGING.
2. Fit the feet with the open end of the foot to the front of the heater.
Secure each foot using the two taptite screws provided.
2.
3. Place the heater on its feet and in the desired position against
the wall. Ensure the heater is based on a
fi
rm level surface at least
75mm from any end wall and at least 250mm below any shelf or
similar projection. Cut away any gripper rod or carpet which would
prevent the heater sitting
fi
rmly on the
fl
oor.
3.
4. Mark the position of the two outside corners of the wall bracket
with the heater pushed tight against the wall. Remove the wall
bracket from the heater by removing the screw at each end. Place
the heater to one side and reposition the bracket against the wall
using the corner marks for alignment.
Four
fi
xing positions must be chosen for the 724N, three for the
718N and two for the 712N. Mark the positions for the
fi
xing holes
- two at the extreme ends and the others spaced evenly between
them. Remove the bracket from the wall, drill the holes in the
positions marked, and insert suitable
fi
xings previously described.
Secure the wall bracket to the wall.
4.
5. If mains connection is to be made from the left hand side, at
this point the mains lead must be secured to the back of the heater
using ties provided in the
fi
xing kit.
5.
6. THE FOLLOWING MUST BE APPLIED WHEN FIXING THE
HEATER TO THE WALL BRACKET
i) If no skirting board is present secure the heater through the wall
bracket slots closest to the wall.
ii) If 100mm (4in.) skirting is present secure the heater through
the outer slots.
iii) If skirting taller than 150mm (6in.) is present this must be
reduced to 150mm (6in.) over the entire width of the heater
plus 25mm (1in.) at each end.
Do not fully tighten these screws until the bricks are loaded into
the heater as some settling of the heater may occur.
NOTE: NEVER REMOVE THESE SCREWS WITHOUT FIRST
UNLOADING THE HEATER.
