EN-6 SES EX-EO_en · 05/15/B
www.dimplex.de/en
Englis
h
Extenter SES EX-EO
3.2 Including the device to the extender
Prerequisite
Extender included on the central unit.
Briefly press the button on the extender three
times. The Info LED on the extender is blinking
blue. This indicates that inclusion mode has been
activated on the central unit.
Switch the device to inclusion mode (refer to the
user guide for the device).
The device is included on the central unit and then ap-
pears in the user interface.
Completion of the inclusion procedure
Automatically after 60 seconds.
Press the button on the extender.
3.3 Excluding the device on the central unit and
extender
Prerequisite
Extender included on the central unit.
Press an hold the button on the extender for around
3 seconds. The Status-LED lights up white.
Briefly press the button an the extender 3 times.
The Info-LED on the extender flashes yellow.
Perform the exclusion sequence on the device (re-
fer to the documentation for the device). The device
is no longer present in the central unit user inter-
face.
3.4 Excluding the extender from the central unit
Prerequisite
Extender included on the central unit.
Start exclusion mode on the central unit. The Info
LED on the extender flashes yellow.
Press and hold the button on the extender for
around 3 seconds. The Status LED lights up white.
Briefly press the button on the extender. The Status
LED flashes white. The extender is excluded on the
central unit. Once it has been successfully ex-
cluded, the Status LED lights up yellow.
NOTE
NOTE
To prevent future inclusion of central unit and extender,
the extender must be excluded or removed on the
central unit.
4. Troubleshooting
Critical error – Info LED flashes red
Remedy:
Reset the device (e.g. disconnect and re-
connect the device).
5. Restoring the factory settings
Press and hold the button on the extender for
around 10 seconds. After around 3 seconds, the
Status LED lights up white. After around another 7
seconds, the Status LED lights up red.
Briefly press the button on the extender. The Status
LED flashes red for 3 seconds and the extender
performs a reset. All connections in the extender
are deleted.
NOTE
NOTE
Restoring the factory settings on the extender has no
effect on the central unit.
6. Power failure
Following a power failure, the extender reconnects it-
self to the central unit on which it was included in the
network the last time.
7. Additional documents
The following additional documents are available in the
download area of our website at:
www.dimplex.de
Operation manual Extender SES EX-ZW
VDE certification
CE declaration of conformity
8. Maintenance and cleaning
NOTE
NOTE
The extender is maintenance-free.
8.1 Cleaning
Switch off the connected device and unplug it from
the extender.
Unplug the extender from the mains.
Clean the extender with a soft, clean, dry and lint-
free cloth.
9. Disposal
Packaging and replaced parts are to be
disposed of in accordance with the regula-
tions of the country in which the device was
installed. Do not dispose of the extender
with household waste; instead, take it to
your local authorised collection point.
10. Warranty
Please contact your local dealer for information an cus-
tomer service and warranty conditions.