THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Electrical Connection
This heater must be used on an ~230V AC supply only and the voltage
marked on the heater must correspond to the supply voltage.
To comply with the I.E.E. Wiring Regulations, the appliance must be
earthed; the supply circuit must be adequate for the input of the
appliance, and the circuit protected by a suitable fuse. This appliance
has a loading of 500 Watts.
If the heater is to be connected to a fixed electricity supply, a suitable
termination must be provided adjacent to the final position of the
appliance. In this instance, such a termination can be a double pole
switch with a contact separation of at least 3mm in all poles.
The SCH5 if converted to floor standing by adding feet must also be
fitted with a rewireable UK 3 pin plug incorporating a 13 amp fuse. The
13 amp fuse must be approved by ASTA to BS1362.
The wires in the mains lead are coloured in accordance with the
following code:
Green and Yellow
– Earth
Blue - Neutral
Brown - Live
General
The Dimplex SCH5 Convector heater is primarily designed for wall
mounting. Feet are, however, available (Part no. CH9101) and enable
the heater to be converted to floor standing units if required.
The heater is designed either for individual operation, or if wall
mounted, may be connected together in multiples with a connector kit
(Part no.CH0471)
As supplied the Dimplex SCH5 convector heater does not have any
controls. Your electrical supplier will be able to advise on timeswitch
or thermostatic controls which would be suitable where multiple
installations are involved.(see warning above).
Safety
For your safety, this appliance is fitted with a thermal cut out. In the
event that the product overheats, the cut out switches the heater off
automatically.
To bring the heater back in to operation, remove the cause of
overheating, then switch off the electrical supply to the heater for a few
minutes.
When the heater has cooled sufficiently, switch the heater on.
Dimensions
Wall mounting (singly)
(Please refer to Fig.1 and 2)
Installation and Operating Instructions
Convector Heater
Model: SCH5
IMPORTANT SAFETY ADVICE
WARNING
–THIS APPLIANCE MUST NOT BE USED IN A
BATHROOM
WARNING - DO NOT USE THIS HEATER IN THE IMMEDIATE
SURROUNDINGS OF A BATH, A SHOWER OR A SWIMMING
POOL.
WARNING
– THIS HEATER MUST NOT BE LOCATED
IMMEDIATELY BELOW A FIXED SOCKET OUTLET.
FOLLOW these instructions carefully.
NEVER cover or obstruct in any way the heat outlet slots at the
top of the heater or the air inlet slots in the base of the heater.
The heater carries a warning ‘DO NOT COVER’ to alert the user to
the risk of fire that exists if the heater is accidentally covered.
If using this heater with a programmer, timer or any other device
that switches the heater on automatically, great care is to be
taken that the heater is not covered or positioned incorrectly
since a fire risk could exist.
This appliance is not intended for use by children or other
persons without assistance or supervision if their physical,
sensory or mental capabilities prevent them from using it safely.
Children should be supervised to ensure that they do not play
with the appliance.
If young children, the aged or infirm are likely to be left in the
vicinity of the heater, we advise that adequate precautions should
be taken. We recommend that a guard be fitted to ensure contact
with the heater s avoided and objects cannot be inserted into the
product.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
.
Fig.2
INDSUKSCH5 Issue 5 (Feb 2010)
Heater must be horizontal with the supply cable at the
right hand end
110mm
Fig.1