Quick Start Guide
Do not place objects within 300mm of
the front of the heater and 150mm (min.
75mm) either side.
ATTENTION: TO PREVENT OVERHEATING DO NOT COVER OR
OBSTRUCT YOUR HEATER.
Programmable timer
1
Display screen
2
‘
Menu’ b
utton
3
‘
Back’
button
4
‘
Advance
’ button
5
‘Selector
Dial’
1
2
3
4
5
11832-2
Rev. 81/91
This is YOUR Control
Make sure both of the wall switches next to the heater are turned to the
On
position and the product has been
programmed with the times you want heat (see full user instructions).
When fi rst switched on your heaters display
screen will perform an initial start-up test, it will then display a room temperature of 21°C.
1.
To Set and Adjust the Room Temperature
Turn the selector dial to the left to lower the heat and to
the right to increase the heat.
The screen will go
Blue
when the temperature is turned
down and
Red
when it’s turned up.
2.
Set your Comfort Level
As a guide, the normal room temperatures are –
Lounge / Sitting room
21°C to 23°C
All Other areas
18°C
We recommend setting the control to
22°C
in the
lounge and
18°C
in all other areas. If the temperature
in the room is too low, adjust the heat level up by 1°C,
too high adjust the heat level down by 1°C. Once the
comfort level has been achieved you no longer need to
adjust this control so its
Set & Forget
(if you do adjust
it this may affect the amount of heat you have stored for
the following day).
3.
When will the Heater Blow Out Heat
The heater will blow out warm air at the times set (see
full Operating instructions) and if the room requires
heat. It also has 2 pre-set timed programs, these are;-
Home
(if you are In all day) - If you have set the
temperature to your chosen level and the room requires
heating, the heater’s fan will blow out heat between –
06.30 - 09.30, 11.00 - 13.00, 15.00 - 17.00 and 18.00 - 22.00
Out all day
- If you have set the temperature to your
chosen level and the room requires heat the heater’s
fan will blow out heat between –
06.00 - 08.30 and 17.00 - 22.00
- 1 -
• To select either of these options press
MENU
button
(2 above) and turn the
Selector Dial
(5 above) in
any direction until you highlight the
Timer Mode
press
Selector Dial
(5 above) once to confi rm.
Home
or
Out all Day
are selected by highlighting
the program you require and pressing the
Selector
Dial
down once.
The times for Home & Out all Day can be changed
– refer to the main Operating Instruction
4.
The Outer Case of the Heater
The ends of the heater will always be cooler than the
middle (the Quantum 125 will have a larger cooler area
on the left-hand side), this is normal.
The areas indicated below will be cooler, this is normal.
Because the majority of the heat is being blown out
of the bottom of the heater it’s very important to
keep this area clear of any obstructions.
