8
www.dimplex.com
Surface Mount
(Figure 6)
Tools Required:
Philips head screwdriver
CAUTION:
Follow “Preparation for Service” instructions
before proceeding.
1. Partially unscrew the rear mounting screws that are
holding the fireplace to the wall along the back panel
of the unit. Support the weight of the fireplace when
loosening the screws so unit does not fall off the wall
unexpectedly.
!
NOTE:
Be sure to take note of which keyhole mount
openings were used for positioning the fireplace so that
it can be re-placed in the same location when service is
complete. (Figure 6)
2.
Take the fireplace off the wall by carefully lifting the
fireplace off the mounting screws so they line up to the
larger part of the keyhole openings and pull forward.
Carefully lay the unit down on a solid flat surface with
the front of the unit facing up.
!
NOTE:
If the surface you are using as a work area on
is a finished surface that is prone to scratches (i.e. hard
-
wood flooring), it is recommended that a protective barrier
be used underneath, (i.e. cloth, cardboard, thick plastic).
3. Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.
4. Once repair is complete, reassemble in the reverse
order as above.
Recessed Mount - Partial In-wall
(Figure 7)
Tools Required:
Philips head screwdriver
CAUTION:
Follow “Preparation for Service” instructions
before proceeding.
1. Remove the 4 mounting screws located approximately
3 inches deep in the space between the outer and
50
5
16
" (128 cm)
19
1
2
(49.5 cm)
46" (116 cm)
48
1
2
" (123 cm)
3" (7.6 cm)
7"
(17.8 cm)
3
13
16
"
(9.7 cm)
18"
(45.7 cm)
16"
(40.6 cm)
Figure 5
Figure 6
Key-hole
Wall stud
Permanent
mounting hole
Mounting Holes
Figure 7
