9
Operation
!
NOTE:
When the unit is used
in an environment where back-
ground noise is very low, it may
be possible to hear a sound which
is related to the operation of the
flame effect. This is normal and
should not be a cause for con-
cern.
!
NOTE:
Always ensure that
the appliance is in a level posi-
tion.
The manual controls for the unit
are located below the control
cover infront of the log grate
(Figure 4).
A. On/Off Switch
Supplies power to the unit.
B. Thermostat Control
To adjust the temperature to your
individual requirements, turn
the thermostat control clock-
wise all the way to turn on the
heater. When the room reaches
the desired temperature, turn
the thermostat knob counter-
clockwise until you hear a click.
Leave thermostat in this position
to maintain the room temperature
at this setting. For additional heat,
turn clockwise until you hear the
click again and the heater will turn
on.
C. Mode Selector Switch
Press
once to turn on the
flame effect. This will be indicated
by an audible “beep”. Although
the lights turn on immediately it
will take 30 seconds before the
flame effect starts.
• Press again to give flame ef
-
fect and full heat. This will be
indicated by two “beeps”.
• Press again to return to flame
effect only. This will be indi-
cated by one “beep”.
•
Press
to put fire in to
standby mode. This will be
indicated by one “beep”.
D. Flame Intensity Control
Adjusts the intensity of the flame
and smoke effect when the heater
B
A
C
D
Figure 4
