see Fig. 6
for details
on settings
To gain access to the lamps, the four screws which secure the back
panel, must be removed. Remove and slide out panel as indicated on
Fig. 8
Two lamps are located behind the back panel as indicated in Fig.7
Fig. 7
Fig. 8
Remove the defective
lamp by unscrewing it as
shown in Fig. 9.
Replace with a 60W E14
SES Clear Candle lamp.
Take care not to over-
tighten the lamp.
Refit the back panel and
secure with the four
screws.
Fig. 9
Lamp Replacement
Using the Remote control
Important Battery information.
Discard leaky batteries.
Dispose of batteries in the proper manner according to
Provincial and local regulations. Any battery may leak
electrolyte if mixed with a different battery type, if inserted
incorrectly, if all the batteries are not replaced at the same
time, if disposed of in a fire or if an attempt is made to
charge a battery not intended to be recharged
.
•
Heat output can be increased or
decreased according to your
particular requirements.
•
The heater can be turned On or Off.
•
Programmable timer.
Fig. 6
On/Off button - see Switch 1 on ‘Operation’.
Provides 1 kW & 2kW heat - see Switch 3
on ‘Operation’.
Runback timer - see Switch 4 on
‘Operation’.
Cold Blow function - see Switch 2 on
‘Operation’.
The remote control consists of 4 buttons (see
Fig. 6). To initialize the remote control, slide
open the battery cover on the back of the
remote. Install 2 AAA type batteries (not incl.),
and replace the cover. Your remote control
is now ready for use. The maximum range of
use is 15metres.
The remote control’s general features are:
Maintenance
WARNING – BEFORE UNDERTAKING ANY MAINTENANCE OR
CLEANING REMOVE PLUG OR DISCONNECT FROM THE
ELECTRICITY SUPPLY.
Fig. 5
Содержание LEE 20RC
Страница 1: ......
