Setting the Timer Programmes
There are four program segments available,
P1
,
P2
,
P3
and
P4
. For each segment it is possible to set a desired
‘On’ time, ‘Off’ time, Heat mode and set temperature. It is
not necessary to set all four segments if not required. The
default setting is for all segments to be Off. To turn off a
pre-programmed segment it is necessary to set both the ‘On’
time and the ‘Off’ time to 00:00. In order to set up a time/
temperature profile the following steps must be completed:
1. To activate the programming screen press the ‘ ’ key.
The program settings screen for
P1
will be displayed and
the time will be flashing. This flashing time is the ‘On’ time
for
P1
and can be adjusted using arrow keys. Once the
desired ‘On’ time has been set press the
ENTER
key to
confirm the time.
2. Select a heat setting using the arrow keys and confirm
the selection using the
ENTER
key.
3. Set the desired temperature using the arrow keys and
confirm the setting using the
ENTER
key.
4. The ‘Off’ time must then be set by using the arrow keys,
it is necessary to then press the
ENTER
key to confirm the
‘Off’ time setting.
5. The setup screen will then revert to the
P1
‘On’ time set
up screen, at this point it is possible move to the
P2
segment
by pressing the ‘ ’ key.
6. If required
P2
,
P3
and
P4
segment can be set up using
steps 1-4 above.
7. If it is not required to set up
P2
,
P3
and
P4
segment at this
stage, continue to press the ‘ ’ key until the heater reverts
to the previous operational mode. Alternatively if no keys
are pressed the programming mode will time out and revert
to the previous operational mode.
Note:
it is possible to overlap the on times of program blocks.
In the event of an overlap the program with the highest
temperature set point will take priority during the overlap
period. Once the overlap period has expired the product will
revert to the later program settings. If an overlap is present
the display will indicate the current operational program and
the off time of the final overlapping program.
Remote Bluetooth Operation
The appliance can be controlled remotely using a
smartphone or similar device. To facilitate this remote
operation it is necessary to first download the Dimplex
app. The app is available on both android and IOS devices
and is available free from the Apple or Android App store.
The App is compatible with Android version 4.3 and above
and IOS version 5 and above.
Once the App has been downloaded it is necessary to pair
the appliance with the smartphone to complete the remote
setup. Please follow the steps shown below:
1. Launch the Dimplex
app on the smartphone or
similar device.
2. To initiate pairing mode on the appliance press and hold
the ‘
’ button for two seconds. The LCD screen will go blank
with the exception of the Bluetooth
logo flashing in the
bottom right hand corner, See
Fig.10.
This indicates that
the device is advertising to be paired with the
app.
3. On the smart phone the appliance should now be visible
on the pairing screen, this will be a unique 6 digit code but
will always start with EC, for example ‘ECBC17’. Select this
device and press connect to initiate pairing.
4. Once the paring process is complete the app can be used
to control the appliance.
5. Once paired successfully the Bluetooth logo will stop
flashing and the Bluetooth neon will be illuminated.
