Operating Instructions
The LED display screen on the control panel of the product illuminates to display what
function you have selected when the fan is operating.
a. Turning on/off the fan:
Gently press “Standby” button
on the soft touch button
control panel or the wireless remote control.
b.
Adjusting and Selecting Speed:
3 contant speeds can be selected by pressing
the button either on the control panel or on the remote. Each time you press
this button the speed will cycle from I to II to III and back to ‘I’ again. Where “
I
” =
Low Speed, “
II
” = Medium Speed and “
III
” = High Speed.
c.
Oscillating function:
The product oscillates in an arc from left to right and back
again continuously thus circulating the air flow over a wider area. To start the
tower fan oscillating simply press the oscillating button on the control panel for
less than 2 seconds or the button on the remote and the symbol will light up
on the control panel. Press this button a second time to stop the oscillating.
d.
Variable Blower Function Selection:
The product can be set to automatically
vary the speed output to simulate different breezy conditions. It will normally run
in constant blowing mode at whichever speed you selected (see “b.” above). To
select a variable blower speed function you can simply press the button on
the remote or press and hold the dual control button on the control panel for at
least 2 seconds. There are two selections available:
1.
The first mode activated will be the ‘natural breeze’ selection and the
symbol
will light up on the control panel. In this mode the fan speed will continuously
and randomly vary between speed levels (including off) to simulate variable
wind conditions.
2. Pressing the on the remote a second time or pressing and holding the dual
control button
on the control panel again for atleast 2 seconds
activates
‘night time’ selection and the
symbol will light up on the control panel. In this
mode the fan speed varies automatically between speed levels (including off)
at a less noticeable rate than the ‘natural breeze’ selection.
- Pressing the button a third time for more than 2 seconds will change it back to
constant normal blowing mode.
e.
Runback Timer function:
The product can be set to switch off automatically after
running for one of the four user selectable runback periods i.e. 1 hr, 2 hr, 4 hr or 8 hr.
To activate the runback function just simply press the timer button
- Press once and the timer is set to 1hr runback
- Press twice and the timer is set to 2hr runback
- Press 3 times and the timer is set to 4hrs runback
- Press 4 times and the timer is set to 8 hrs runback
-
Press a 5th time and the timer function is switched off.