4
5
5. Other than on the case of note 2 above, where the dehumidifier does not
start, the operational light does not illuminate or the dehumidifier
intermittently stops for unknown reasons, please check the plug and power
supply for poor connection. If the plug and power supply are in good
condition, wait for 10 minutes and restart the unit (it can take about 10
minutes for the unit to reset). If the unit still does not start after 10 minutes,
please contact your retailer or the manufacturer for repair.
6. When the dehumidifier is in operation, the running compressor will
produce heat. This is normal and may potentially raise the room
temperature.
7. When the product is defrosting, related indicating light will illuminate.
DRAINAGE INSTRUCTION
Switch off before carrying out any of these operations and leave for 3 minutes
before switching on again. The extracted water is collected by the water tank
(set up as supplied), or can be set up to drain continuously using a PVC hose
(not included) connected to a water outlet tube , the drain point must be lower
than the unit outlet (see details below).
USE OF WATER TANK:
When the tank full LED illuminates the tank is full, the
compressor and the fan will stop operation, please
empty the water tank. Remove the water tank:
Remove the water tank as per Fig 01 and empty it.
Gently refit the water tank into the unit in its original
position.
CONTINUOUS DRAINAGE
If you want to use this function, please pull out the water tank and plug a 9mm
internal diameter water pipe onto the “Water out
tube” (See Fig.02).Replace the water tank into the
unit, the unit will now operate while discharging the
extracted water through the free end of the fitted
pipe, Note, please ensure the free end is below the
outlet connection.
Please ensure drain away is lower than the unit
outlet.
Filter Removal
To remove the filter you must first remove
the water tank as instructed above.
The filter can then be removed from its slot
by gripping the filter handle and sliding it
down and out of the back of the appliance
as indicated below.
Every 2 weeks, remove the filter and clean
it with warm water, below 40°C. Allow it to
dry naturally and then replace by reversing
the removal instruction above
Care and Maintenance Instruction
1. To avoid the occurrence of vibration and noise the unit should not be
operated while located on any soft or uneven surface.
2. Never insert any foreign objects into the unit through its air inlet or outlet to
avoid hazard or unit failure.
3. During power off or when not in use for a long time, please disconnect the
product from the mains.
4. For a better dehumidifying effect, the areas in the front and rear of the
unit should be clear and free from any obstacles which will block the air
flow of the unit. Do not block any air inlet or outlet grilles – keep clear of
hanging drapes, curtains and furnishings-
DO NOT COVER.
Fig 01
Fig 02
